Acurite 01035 Weather Station User Manual download pdf (Page 15)

DISPLAY CONSOLE MAINTENANCE:

Clean with a soft damp cloth, do not use caustic cleaners or

abrasives as these will damage the finish on the display console.

Keep away from dust and dirt and moisture, dust ventilation ports

regularly with a gentle puff of air, this will keep the indoor

temperature and humidity accurate.

INTEGRATED WIRELESS SENSOR MAINTENANCE:

Clean the housing with a damp cloth, do not use abrasive cleaners

or any materials that will mar the polished surfaces of the rain

collection funnel or the solar panel- this will result in decreased

performance and reliability.

Occasionally remove the rain collector screen cup and empty it. This

will filter out seeds and small sticks, etc. (the rain collector screen cup

is located within the rain funnel- remove from the top gently by

squeezing and pulling out).

Remove any foreign matter on the outside of the housing to allow for

free movement of wind vane and anemometer.

INSECTS: in most cases, insects will not pose a problem. However, in

some instances, insects may cause repeated obstructions to weather

measurement by nesting or building homes in or on the integrated

wireless sensor. In these cases, it may help to spray the housing with

a commercially available home insect guard/repellent product (not

included) to limit the problem. Please consult the insect repellent

manufacturers instructions and safety information before using.

BATTERY SAFETY:

Clean the battery contacts and also those of the device prior to

battery installation. Remove batteries from equipment which is not to be used for an

extended period of time. Follow the polarity (+/-) diagram in the battery

compartment. Promptly remove dead batteries from the device. Dispose of used

batteries properly. Only batteries of the same or equivalent type as recommended

are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in

fire, as batteries may explode or leak. DO NOT mix old and new batteries or types

of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT

recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

MAINTENANCE TROUBLESHOOTING

Problem

Bad

Wireless Sensor

Reception

Display Console

Screen Not Working

No Wireless Sensor Data

(no communication)

Possible Solution

no bars

no bars and flashing

“ -- ” data

Relocate the main unit and/or the wireless

sensor. Both units must be within 330 feet

(100m) from each other. Make sure both

units are placed at least 3 feet (.91 m) from

other electronic appliances and devices that

may interfere with the wireless

communication (such as TVʼs, microwaves,

computers etc). NOTE: It may take up to 20

minutes for the main unit to re-synchronize

with the sensor when batteries are replaced.

Use lithium batteries in sensor when

temperature is below -4ºF (-20ºC).

If wireless reception is bad (no bars), see

“Bad Reception” section above. The wireless

ID setting on each unit must match for all

units to communicate properly. See “Set

Wireless ID” on the next page.

Batteries may need replacing

Check that AC adaptor is fully inserted if

running off AC power only

USB Connectivity

is not working

Check that the USB cable is securely

connected to the display console AND to

your PC USB port.

Confirm that the correct mode is selected.

I Cannot Access

my Data Online or

from the APP

Check that the USB cable is securely

connected to the display console AND to

your PC USB port.

Confirm that USB mode 3 or 4 is selected.

Make Certain that the display console is

powered on.

Confirm your display console DEVICE I.D. /

M.A.C. number is entered into your online

account correctly at www.acu-link.com

2726

1 2 ... 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Acurite 01035 Weather Station User Manual Page 15

Comments to this Manuals

Related products and manuals for Thermometers Acurite 01035 Weather Station